Wyred-4-sound mINT User Manual download pdf (Page 11)

pg. 9

15. 120V/230V Mains Voltage selector switch.

Troubleshooting

No sound?

If you have your input source and speakers connected, and you can’t get music to

play, check the following. Feel free to test for output at any time during this process

if you find and correct a potential problem.

Always check the position of the volume knob before starting to play music.

Damage to any equipment due to the volume being set to high is not covered

under warranty.

1. Verify that the power cord is securely plugged into the wall and the mINT.

2. Check the switch on the rear to verify that it is in the on position. Make sure that

the blue light is on around the power button and the proper input is selected. If the

light around the power button is green, the power button will need to be pressed

once to turn the integrated on.

3. Check the position of the volume knob. The point where sound will become

audible varies with each system although it is typically around ¼ turn up (clockwise)

from the lowest setting (all of the way counter-clockwise).

4. Put your ear next to the tweeter of your speaker and have someone turn your

amplifier off then on again at the switch. You should barely hear a click when the

amplifier is turned on and off

5. If you can hear the amplifier turn on and off, but there still isn’t any sound, make

sure you are getting a signal to it. You may consider trying a different source.

6. If the input is in the proper position and you are confident that your source is

sending a signal but have no sound, try inspecting or replacing your interconnects

and speaker cables.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Wyred-4-sound mINT User Manual Page 11